Liquid Plastic requires no extra attention to get rid of air bubbles because it releases them on its own due to its long cure time and low viscosity. If you’re pouring over a surface that may release air during the 3-day curing process then those bubbles may get trapped and ruin your crystal-clear look. A sealer coat is advisable in this case.

UVPoxy is a much thicker and faster curing epoxy, which requires extra attention to bubbles. A torch or heat gun is advisable for popping any surface bubbles, and slow mixing/folding of the product helps to avoid excess air entrapment in the batch. Using a pressure pot works well for all our products.

Previous Next
Close
Test Caption
Test Description goes like this